Features
HOW THEY WORK
 A) MIX:
Pour powder from one capsule into the deep side of the carry case, by gently twisting the capsule ends apart. Remove bottle lid, snap off tip and dispense 7 drops ( for "Shredders" use 14 drops )onto the powder. Pick up the case in your hand and tilt slightly. Stir with the stick provided for 10-15 seconds until the mixture is uniform and just pasty while keeping the material in a glob at the lower edge of the tilted case as not to waste any.
|
|
 B) FIT:
Scoop the glob of material into one fang, applying it onto the front and back as evenly as possible rather than just filling up he cavity in the fang. Gently push the fang all the way up onto your tooth, attempting to locate the best position in one motion as discussed. Try not to wiggle, adjust or reposition the fang after you push it all the way up. Leave it on for 5 minutes so it can harden, but do not remove it yet, and don't work on the next fang until 5 minutes has passed so that you don't accidentally loosen it before it sets up. With the first fang in place, position the next fang in a mirror. Orient this fang relative to the first so that it has a similar angle and looks natural. After you practiced putting it on accurately, follow steps A and B again.
|
|
 C) REMOVE:
These fangs fit tight! If you like how they look after you finish customizing, leave them on. When you are ready to take them off, gently push your lower teeth forward against the backside of the fang tips until you hear a slight click. The wiggle and pull gently with your fingers until they loosen up. it may take a minute the first time you remove them, they are meant to fit tight. Your fangs will now clip on and off easily. If desired, trim off the excess material that shows on the front of the fangs with a nail clipper or scissors.
| |
|
